Quantcast
Channel: Lowrider
Viewing all articles
Browse latest Browse all 727

Building a Cover-Worthy Caprice After Two Decades

$
0
0

Building Caprices and being featured in LOWRIDER magazine isn’t anything new to Jaime Tapia. This is the Santa Ana resident’s sixth Caprice build and the fourth time being featured on the pages of LOWRIDER. What is new for him is landing the cover of LOWRIDER. “I looked at all the cars on the cover of LOWRIDER and used that to guide me in the build but while keeping an old-school look to it.” Jaime’s been lowriding since 1994 and he credits his start to his cousin’s love of lowriders and his father who owned a Caprice.

1975 chevrolet caprice low shot

Jaime picked up this 1975 convertible that needed everything done to it by trading a fully done up 1973 Caprice that was featured in LOWRIDER back in 2008. “It wasn’t a straight trade since this one needed everything,” Jaime explains.

1975 chevrolet caprice side mirror 1975 chevrolet caprice molded control arm 1975 chevrolet caprice cpp steering wheel

The build began when Clemente (a member of Viejitos) pulled out the original 350 motor to rebuild it. The block was painted to match the paint and a four-barrel Edelbrock carb was slapped on top. This was just the start of the motor buildup as it received ball-milled billet valve covers and air filter. Chrome headers and a water pump was added but before the motor was dropped back in, Jaime shaved the firewall to give it a clean look.

1975 chevrolet caprice hoppos whammy pump

During his spare time, Jaime began modifying the car by first replacing the front end with 1976 one. This replaced the round headlights with square ones. He then shaved the door handles and molded the trunk and hood. Jazz Auto Body then received the convertible to finish the bodywork and have Armando lay the House of Kolor hot pink paintjob. Armando laid ghost patterns by using candy purple with magenta fades in the hood, trunk, sides and engine compartment. Manny Auto Art then came in to add purple and pink striping to outline the patterns and also ended up engraving all four bumper guards. Oscar Graphics added the finishing touches to the paint by airbrushing a mural of two females and the cars name under the molded trunk.

1975 chevrolet caprice lowerd front

Herman Sanchez then molded the upper and lower arms and reinforced the frame, and 1995 Impala disc brakes were then modified to fit with the stock rearend. AP Show Chrome dipped everything in the motor and undercarriage (including the gas tank) in chrome.

Joe at California Upholstery wrapped the Honda Accord seats in raspberry and pink vinyl and added custom door panels with painted inserts. A custom fiberglass center console was built that went from under the front dash all the way to the back dash. It was then painted and striped to match the car. A billet CPP steering wheel and custom kick panels to house 6 1/2-inch Pioneer mids were added to finish the interior.

1975 chevrolet caprice driver seat

Work inside the trunk began when MG Auto Sounds installed the all-Pioneer sound system that includes two 12-inch subwoofers. Herman Sanchez then installed a Hoppo’s double whammy with an engraved tank. Three old-school slow downs, three square dumps, engraved monster check valves, six batteries, and hand-bent steel tubing was added to finish up the hydraulic setup. Omar Estrada wrapped the trunk in fiberglass that was painted and striped. Then 13-inch 100-spoke Galaxy wire wheels with 5.20 Premium Sportways were slapped on to complete the build.

“Everything fell into place with the build,” Jaime explains. The only thing he had to get redone was the interior. He originally had a lighter shade of pink but once he did the top in a raspberry color he felt that the interior didn’t go with the rest of the car. Once the car was competed it sat in the garage for a year before it was taken out to a show. “I waited for my club members to finish their cars so we could all show together.”

1975 chevrolet caprice hydraulic dump 1975 chevrolet caprice aerial view 1975 chevrolet caprice custom console seat

1975 Chevrolet Caprice

Vehicle Nickname
Pink’n Aint Eazy

Owner
Jaime Tapia

1975 chevrolet caprice jaime tapia

City/State
Santa Ana, CA

Club
Latin Life

1975 chevrolet caprice 350 motor

Engine
Stock 350 engine with ball milled air filter/valve covers, chrome water pump, Edelbrock carburetor, Flowmaster exhaust, aluminum radiator, and electric fan

Body/Paint
Shaved door handles, updated frontend and molded firewall, trunk, and hood. The raghouse was then sprayed with House of Kolor hot pink with candy purple and magenta patterns.

1975 chevrolet caprice air tank engraving

Suspension
Molded upper and lower arms and 1995 Impala disc brakes mounted to the original rearend and a chrome Hoppo’s whammy pump with three slowdowns and six Interstate batteries

Interior
The custom seats were wrapped in raspberry and pink vinyl and a CPP billet steering wheel was added to finish the interior

1975 chevrolet caprice custom painted hood

Sound
Pioneer deck and Pioneer amps, mids, and subwoofers

Wheels/Tires
13-inch 100-spoke Galaxy wire wheels with Premium Sportways 5.20s

1975 chevrolet caprice quarter view 1975 chevrolet caprice latin life club plaque 1975 chevrolet caprice inner fender cover

The post Building a Cover-Worthy Caprice After Two Decades appeared first on Lowrider.


Viewing all articles
Browse latest Browse all 727

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>